Double-click on the relevant surface to open the "Edit Surface" dialog box. You can use the Select function to select the boundary lines. If lines that are already in the list are selected again, they are removed from the list. This option allows you to save a lot of time, especially for geometrically complex surfaces with many boundary lines.
Changing Boundary Lines of Surfaces
Mr. Fröhlich provides technical support to our customers and is responsible for development in the area of reinforced concrete structures.
In the Concrete Design add-on, you have the option to define an existing vertically oriented punching shear reinforcement. This is then taken into account in the punching shear design.
In RFEM, the oriented strand board (OSB) material is available for the USA and Canada. The material parameters are taken from the "Panel Design Specification manual".
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
The "Base Plate" component allows you to design base plate connections with cast-in anchors. In this case, plates, welds, anchorages, and steel-concrete interaction are analyzed.